Aquarium Cradle Swing
Cradle
(Seat moves side to side)
Swing
(Seat moves front to back)
Model Number: 79667
Please read these instructions before use of this swing.
Keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips screwdriver (not included).
Requires four “D” (LR20) alkaline batteries for operation (not included).
Maximum Weight Limit: 24 lbs. (10.9 kg.)
IMPORTANT! If your child weighs less than 24 lbs., but is really active and appears
to be able to climb out of the swing, immediately discontinue its use.
Product features and decorations may be
different than shown in photos above.
Parts
Motorized Frame
Note: Please remove tape that was
added for packaging purposes.
Storage
Pouch
Tray
4 Toys
Pad with
Headrest
Seat Tube
Arm
2 Upper Legs
Seat with Restraint System
2 Feet
2 Lower Legs
1
#8 x / " Screw - 2
2
M5 x 30 mm Bolt - 2
M5 Lock Nut - 2
ALL SHOWN ACTUAL SIZE
3
Assembly
IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed.
Never substitute parts.
Button
Hole Up
Button
Hole Up
1
#8 x / " Screw - 2
2
SHOWN ACTUAL SIZE
Storage
Pouch
Pockets
Foot
Lower Leg
Upper
Legs
1
• Position a lower leg so that it stands on a flat surface, as shown.
• Fit a foot onto the end of the lower leg.
1
2
• Insert a #8 x / " screw through the bottom of the foot
and into the lower leg. Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
3
• Repeat this procedure to assemble the other foot to the
other lower leg.
• Position the storage pouch with the pockets toward you,
and the button holes are up.
• Position the legs so that the feet are away from you.
• Slide the storage pouch onto the upper legs.
Red Dot Up
Upper Leg
Straight
End
Button
Rivet
Through
Button
Hole
Button
Hole
Hole
Lower Leg
2
4
• Position an upper leg so that the red dot is up.
• While pressing the button on the straight end of an upper
leg, insert the upper leg into a lower leg. Make sure the but-
ton on the upper leg “snaps” into the hole in the lower leg.
• Repeat this procedure to assemble the other upper leg to the
other lower leg.
• Fit the rivets on the upper legs through the button holes in
top ends of the storage pouch.
4
|